1L6 ) Luxur Y-Lift; And Heat Assembly Instructions - La-Z-Boy Luxury-Lift Instrucciones De Operación

( 1L6 ) Luxur y-Lift

6-Motor Massage & Heat Assembly Instructions:
NOTICE:
Do not plug the transformer in until instructed.
1. Locate and identify the connectors. Do not connect until instructed.
• Lay the back across the arms of the body (F
• Locate the eight wires with connectors. Four wires come from the lower
back, one from the rear of the seat, one from the arm and two from
under the seat near the motor (F
• The two large round connectors identified with yellow tape are for the
Hand Wand connection.
• The other two large round connectors are for the Lift Motor connection.
• The two small round connectors are for the Power Supply connection.
• The two rectangular connectors are for the Massage Motor connection.
WARNING
- To reduce the risk of injur y:
• Do not operate the unit until the back is installed and locked.
2. Install the back.
• With the back across the arms of the body, lift the back at a slight angle
and align the brackets on the back with the brackets on the body (F
• Lower the back onto the body, making sure the back and body brackets
are completely engaged.
• To make sure the back is properly installed with both sets of back and
body brackets engaged, stand behind the chair and twist the back from
side to side. If one or both sides move out of position the brackets are
not engaged (F 4). Remove the back and repeat the steps above.
IGURE
• If you are unable to install the back properly contact your La-Z-Boy
dealer for assistance.
• Lock the brackets using a screwdriver to push down the locking levers
(F 5).
IGURE
3. Connect the Hand Wand.
• Align the white dots on the Hand Wand connectors. The Hand Wand
connectors are identified with yellow tape. Push the connectors together
until they are secured with no gap between them.
4. Connect the Lift Motor.
• Align the white dots on the Lift Motor connectors. Push the connectors
together until they are secured with no gap between them.
5. Connect the Power Supply.
• Align the connectors and push together until they are secured with no
gap between them.
6. Connect the Massage Motors.
• Align the clips for the Massage Motor connection. Push the connectors
together until they lock.
(Assembly Instructions Continued)
10
®
Power Recliner with
1).
IGURE
1 and F 2).
IGURE IGURE
( 1L6 ) Luxur y-Lift
6-Motor Massage & Heat Assembly Details:
F 1
IGURE
Massage Motor
Connector
Power Supply
Connector
3).
IGURE
F 3
IGURE
®
Body
Bracket
Back Bracket
®
Power Recliner with
F 2
IGURE
Hand Wand Power Supply
Connector Connector
Lift Motor Massage Motor
Connector
Connector
F 4
IGURE
Back and body brackets on this side are not
engaged. Remove the back and reinstall.
F 5
IGURE
Back
Bracket
Locking
Lever
Locked
Position
Lift Motor
Connector
Hand Wand
Connector
11