Braglia DATA-MATE 200.302.77 Manual De Instalación De Montaje página 32

6.2.2 LEVEL
Pressione
Livello
Flussometro
Velocita'
The level sensor is a pressure transducer working at 12 VDC and providing a 4-20 mA output signal. Some parameters can be set up to customise
operation of the instrument:
- Reading frequency: by means of this parameter, you can establish the time DATA-MATE takes to update the pressure/level readout. The parameter
is in milliseconds and can range from a minimum of 500 ms to a maximum of 2000 ms. The default setting is 1000 ms;
- Sensitivity: by increasing this parameter, given as a %, you reduce the number of sampling operations used to calculate average pressure/level. By
setting 100%, DATA-MATE will perform one sampling operation (50 Hz sampling frequency, 0.02 s delay). By setting 1%, you will calculate the average
value of the last 300 recorded (6 s delay). the default setting is 50%;
- Full scale: set the sensor's full scale value. The default setting is 250 mbar;
- Alarms: it is also possible to establish the minimum and maximum level thresholds. The parameter will start flashing and the acoustic alarm will be
activated when the level rises above or drops below the thresholds. In display mode, you can deactivate the acoustic alarm by pressing
parameter in alarm condition will keep flashing until the corresponding value is within the permissible range;
- Resetting: this should be performed with the sprayer halted, a '0' level value and when the value does not correspond. Resetting must be performed
with the tank empty and the sensor connected. After opening the menu, confirm with
6.2.3 FLOWMETERS
Pressione
Livello
Flussometro
Velocita'
Impulsi
Auto Calibrazione
200.1012.15
SENSORI
SENSORI
IMPULSI F1
250 Pul/l
Letture
Sensibilità
Fondoscala
Allarmi
.
10 / 22
LIVELLO
1000 ms
50 %
250 mBar
FLUSSOMETRO
Impulsi F1
Allarmi F1
Sensibilità F1 50 %
Impulsi F2
AUTOCALIBRAZIONE
Premere OK
E iniziare
L'erogazione
. The
Rev. 01 01/02/2016