Preparation For Operation - IKAR HPL Manual Del Usuario Original

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 48
GB
1
Abb. 5
Abb. 5
Before the IKAR Tripod can be operated, its appropriate mounting must be verifi ed by
Abb. 8
The operating instructions of the IKAR Tripod as well as of other IKAR devices
Adjustable rubber moulded feet:
Abb. 8
5

Preparation for operation

IKAR Tripods
Setup the tripod vertically () .
Fold the legs outwards. To do this push in the locking pin ( + ). Swing the
leg out until it latches in audibly. Repeat with the other 2 legs. Take care that
the tripod is vertical. To adjust the height of the individual extendable legs,
fi rst release the socket pin with the thumb () and pull it out. Adjust the leg to
the desired length and secure it with the socket pin. Repeat with the other 2
legs. If the ground is uneven, the legs can be adjusted to different lengths to
compensate. Then align and position the tripod. Take care that it is stable. To
dismount the tripod, follow the steps in reverse order.
2
Abb. 5
Abb. 6
Abb. 8
an authorized person according to BetrSichV Section 14
[Management of Health and Safety at Work Regulations].
Then the IKAR Tripod can be operated.
must be observed at all times.
6
Abb. 6
3
Note:
Abb. 7
Abb. 7
For an optimum adjustment to the conditions
and the ground, the tripod has foldable rubber
moulded feet. The horizontal position () is
recommended for hard and stable grounds.
The vertical position is recommended for softer
grounds (). It keeps the tripod from sliding.
24
Abb. 6
4
Abb. 7
Abb. 5
Abb. 8

Publicidad

Tabla de contenido
loading

Tabla de contenido