BOZZA BZ-2000 Instrucciones De Montaje página 42

2.2.1 Unit set: press "sw1" and "sw2" key not exceed 5s to enter the unit
set pattern; press "sw1" button to select the unit needed , then press "sw2"
key not exceed 1s to quit the setting pattern, the digit blinks will stop.
2.2.2 To zero out: Press "sw1" button to display the screen about 1s,
"0.0mL" appears or Unqualified.
2.2.3 Display: Press "sw1" and "sw2" button simultaneously to display the
fixed parameter "1.000 " and total value, then down the key to restore
"0.0mL".
2.2.4 Power alarm: Voltage below 2.6V., twinkle appears.
2.2.5 Automatically fixed coefficients: Press the "sw1" for 1s , the 1
section will display "0.00L", Use the standard grease pump to transfer until
grease empty, 1 section digit will display "x.xxL"; Press "SW2" for more
than 3S to enter the parameter setting model, then 1 section appear
"00x.xxL"; Press
"SW2" to revise the Digits, then press "SW1" to adjust the value
appears—here input the size for standard barrel; then press " SW2" for
more than 3S, exit to auto modification model, then the fixed coefficients
are automatically generates.
2.2.6 The grease control valve to work in stable condition.
1) Press " SW1" to zero out
2) Aim the grease control valve at the container which size known,
dispensing the grease
until the grease more than two thirds of the container position. 1 section will
display "xxxL";
3) To get the net weight of the container;
Press " SW2" more than 3S to enter the parameter setting model, 1
sectiondisplay " 00xxxL"; Press " SW2" to select the digits, then press
"SW1" to revise the digit value; Input the net weight of the grease, then
press " SW2" more than 3S to exit the auto modification model, then the
fixed coefficients are automatically generates.