Trobleshooting Guide - BOZZA BZ-2000 Instrucciones De Montaje

TROBLESHOOTING GUIDE

Trouble
Grease leakage from trigger
Grease leakage from bottom
Grease leakage from the upper
No working of the trigger
No displaying of crystal screen
Inadequate precision measuremet
Flow reduced or no output
Normal output but no measurement Installation errors of oval gear after cleaned
Trigger out but grease on outputting Misplace of trigger
F.7.Table 5: Fatigue spare parts list of grease control valve.
F.8.Table 6: Other spare parts of grease control valve.
Description
1/4" Z Swivel
Grease Pipe
Grease Coupler
F6.
Table 4: Troubleshooting Guide
Reason
Damage of top clubs 22 or steel ball 3
Loose connection 1
Wear of sealing ring 25
Hand round regulator 19 squeeze
Battery out of charge
Loss of precision instrument
Air mixed into the grease
Grease knot
Circuit board failure
Offset positioning of steel ball
Part no. Description
6 Oval gear
13
16
25
30
32
33
34
35
Thread
1/4"BSP
1/4"NPT
1/8"BSP
1/8"NPT
1/8"BSP
1/8"NPT
Solution
Replace top clubs or steel ball
Re-tighten it
Replace it
Adjust or replace it.
Replace the battery.
Refer to 2.2.5, re-set fixed coefficient
Adjust the working position of pump
Refer to F.4, clean gear&body cavity.
Re-installation
Replace the circuit board
Adjust the trigger
Re-assemble it.
Battery
O-ring
Seal mat
Steel ball
Washer
O-ring
O-ring
!
Washer
Photo