1. Locate the factory wiring harness in the dash.
Metra recommends using the proper mating
adapter from Metra or AXXESS. Re-connect the
negative battery terminal and test the radio for
proper operation.
2. Slide the aftermarket radio unit into the factory
brackets and secure the unit to the brackets using
the screws supplied with the head unit. (Figure A)
3. Secure the aftermarket radio unit and factory
bracket assembly into the sub dash. (Figure B)
4. Place the Double DIN trim plate into the back of
the radio housing, then attach the clock/hazard
switch bracket assembly using the (4) #6 x 3/8"
Phillips pan head screws. (Figure C)
WARNING: DO NOT OVERTIGHTEN SCREWS.
5. Clip the clock/hazard switch assembly into the
99-8214 radio housing trim panel. (Figure D)
6. Reassemble dash in reverse order
of disassembly.
Kit Assembly 99-8214
Double DIN radio provision
(Figure A)
(Figure B)
6
(Figure C)
REAR VIEW OF
Rear view
RADIO HOUSING
of radio
housing
Double DIN
DOUBLE DIN TRIM PLATE
trim plate
RESTORE
RESTORE
CLOCK/HAZARD SWITCH
CLOCK/HAZARD SWITCH
BRACKET ASSEMBLY
BRACKET ASSEMBLY
(Figure D)
Restore
clock/hazard
switch racket
assembly