Fan Assembly. Pgs - Craftmade ELLINGTON E-DL60DMI5CRW Guia De Instalacion

5. Fan Assembly.
If you wish to extend the hanging length of your fan,
you must remove the hanging ball from the 6in.
downrod provided to use with an extended downrod
(sold separately). [If you wish to use the 6in. downrod,
please proceed to instructions following the dotted line
below.]
To remove hanging ball, loosen set screw on hanging
ball, lower hanging ball and remove stop pin. Slide
hanging ball off the original downrod, A, and slide it
down the longer downrod, B (the top of the downrod
should be noted as having a set screw hole; use this
hole when setting the set screw). Insert stop pin into
top of extended downrod and raise hanging ball. Be
sure stop pin aligns with slots on the inside of the
hanging ball. Tighten set screw securely.
Remove vice from safety cable by loosening the screw
and nut on the vice.
Tip: To prepare for threading electrical wires through
downrod, apply a small piece of electrical tape to the
ends of the electrical wires--this will keep the wires
together when threading them through the downrod.
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. Slide downrod through canopy and yoke cover.
Thread safety cable and electrical wires through
downrod and pull extra wire slack from the upper end
of the downrod.
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert pin
and clip that were previously removed. Securely
tighten yoke set screws and nuts. Lower yoke cover to
motor housing.
Remove blade arm screws and lock washers from
underside of motor and then remove stabilization
plate.
Important: Stabilization plate may be discarded once
removed BUT SAVE BLADE ARM SCREWS AND LOCK
WASHERS FOR LATER USE.
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
A
electrical wiring
canopy
pin
stabilization
plate
page 4
set screw hole
stop pin
hanging ball
B
vice
safety cable
downrod
yoke cover
yoke set screw
clip
motor
housing
blade arm screw
and lock washers