Motor Housing; Wiring. Pgs - Craftmade ELLINGTON E-DL60DMI5CRW Guia De Instalacion

5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang
your fan. Grab the fan firmly with two hands. Slide
downrod through opening in hanging bracket and let
hanging ball rest on the hanging bracket. Turn the
hanging ball slot until it lines up with the hanging
bracket tab.
WARNING: Failure to align slot in hanging ball with tab
in hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you once
you are set on the ladder.
Find a secure attachment point (wood ceiling joist
highly recommended) and secure the safety cable. It
will be necessary to use a heavy duty wood screw,
washer and lock washer (not supplied) with the safety
cable loop. Extra cable slack can be left in ceiling area.
Replace vice on safety cable and adjust safety cable
length by pulling on the cable. Adjust slack in cable to a
hands length and secure vice by tightening screw and
nut securely. [Refer to drawing at right.] The loop at the
end of the safety cable should just fit over the threads on
the wood screw. Test safety cable by pulling on loose end
with pliers. If the safety cable slips, the vice and nut must
be set tighter.
6. Wiring.
CAUTION: Be sure outlet box is properly grounded or that
a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to on the next page, please use a qualified
electrician.
["Wiring" instructions continued on next page.]
Modifications not approved by the party responsible for compliance could
void the user's authority to operate the equipment.
*NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
wood
ceiling joist
page 5
safety cable loop
wood screw
and washer
screw
nut
safety cable
hanging bracket tab
hanging ball slot

motor housing