Automated Learning Process./ Activating Code; Important - Craftmade ELLINGTON E-DL60DMI5CRW Guia De Instalacion

9. Light Kit Assembly. (cont).
Install 3 candelabra base 40 watt max. bulbs
(included).
Important: When you need to replace bulbs, please
allow bulbs and glass shade to cool down before
touching them.
Remove finial, finial plate, threaded washer and
rubber washer from bottom of light kit fitter.
Place rubber washer inside glass shade over center
hole. Align hole in center of glass shade with
threaded rod on light kit fitter and push up gently
until threaded rod comes through hole. Secure glass
shade with threaded washer. Note: Do NOT
overtighten threaded washer as glass may crack or
break.
Align hole in center of finial plate with threaded rod
and push up. Re-attach finial. Note: Do NOT
overtighten final as glass may crack or break.
10. Automated Learning Process./
Activating Code.
CAUTION: The remote control transmitter can be
programmed to multiple receivers or fans. If this is not
desired, turn wall switch off to any other
programmable receiver or fan.
Remove battery cover on back side of remote
control transmitter.
Use a ballpoint pen or a small screwdriver to set the
code switches 1 through 4 for the transmitter. Use
the same number sequence used when wiring the
wall control in Section 6 (page 6).
Note: The dimmer switch (labeled D and X) has
been pre-set to the "ON" position (D). If you do not
wish to have dimming capability, please move the
switch to the "OFF" position (X).
Install 9-volt battery (sold separately) in transmitter
and then replace the battery cover.
IMPORTANT: Store the transmitter away from
excess heat or humidity. To prevent damage to
transmitter, remove the battery if not used for long
periods.
Restore electrical power and then set slider switch
on wall control to the ON position. Within 30
seconds of turning on the wall control, press the
"OFF" button, located on the front of the
transmitter, for 5 seconds or until lower light blinks
twice. Test the light and fan functions to confirm
the learning process is complete--see Section 13.
bulb
finial plate
dimmer
switch
page 8
light kit
fitter
glass shade
threaded washer
finial
TRANSMITTER
(back)
switches
battery
cover
TRANSMITTER
(front)
motor
housing
dip