Operation Via Repeater; Offset Programming; Offset Direction - Dynascan P-72 Manual De Instalación

* Blank space
#
Note:
- The [A/B] to [DEL] keys on microphone are with default pre-set features as below:
[A/B]: A/B-PF1.
[MENU]: MENU-PF2.
[VFO]: VFO/MR-PF3.
[DEL]: DEL/PF4.

8.5.- OPERATION VIA REPEATER:

The repeaters are typically used to long-distance communications and are mostly installed on top of
a mountain or other high locations.
Example of installation of a repeater:
Note:
- The most repeaters use receive and transmit frequency with a standard or non-standard
offset.

8.5.1.- Offset programming:

1. Press and hold the [PTT/CLR] key for more than 3 seconds to select the operation band (CTRL).
2. Press the [MENU] knob to access the current band menu.
3. Rotate the [MENU] knob to select the settings, and then press the [MENU] knob to confirm.
4. Rotate the [MENU] knob to select function, and then press the [MENU] knob to confirm.
5. Rotate the [MENU] knob to select the offset direction or offset step options, then press the
[MENU] knob to confirm.

8.5.2.- Offset direction:

● To select the offset direction, could make your TX frequency higher (+) or less (-) tan your RX
frequency.
● Once selection done, press the [MENU] knob for confirmation.
>> Screen will show up "Saved".
Down
Up To switch character input type
English - 26 -
*
#