Scan On/Off; Vfo Scan; Channel Scan List - Dynascan P-72 Manual De Instalación

Notes:
- If setting the squelch level or press other keys except the [TONE/T.SET] and [B/E] during
scanning, it will stop scanning.
- When operate with CTCSS/DCS, the transceiver will stop scanning when receive any
matching signal
- When operate with CTCSS/DCS, the transceiver will stop scanning when it receives any
frequency that incorporates CTCSS/DCS matched signaling with the one programmed on
your transceiver.
- If you select the scan mode during scanning, the transceiver will stop scanning.

9.9.1.- Scan ON/OFF:

When the scan is enabled, the transceiver will start scan cyclically to check if there is any activities
on the channel of preset scan list. Once the scan is ON, the led will flash, and scan icon
displayed at the right on scanning band.
● Press and hold the [PTT/CTRL] key for 3 seconds to select the currently operation band (CTRL).
● Press and hold the [VOL/SCAN] key for 3 seconds to turn ON/OFF the scan function.
To program the scan function:
1. Press and hold the [PTT/CTRL] key for 3 seconds to select the currently operable band (CTRL).
2. Press the [MENU] knob to access menu list.
3. Rotate the [MENU] knob to select the scan options, and press the [MENU] knob to confirm.
● The scan will be display on the screen.
4. Turn the [MENU] knob to select the below described scan options.

9.9.2.- VFO scan:

● Press the [MENU] knob to confirm the option.
● "Start scanning" will display on the screen, and return to main screen.
● Scan icon
will display at the right of scanning band.

9.9.3.- Channel scan list:

● Press the [MENU] knob to confirm the option.
● "Start scanning" will display on the screen, and return to main screen.
● Scan icon
will display at the right of scanning band.
English - 34 -
will be