Scan Off; Scan Mode; Scan List; Scan List Operation - Dynascan P-72 Manual De Instalación

9.9.4.- Scan OFF:

● Press the [MENU] knob to confirm the option.
● The screen will return to main interface.
● Scan icon
will be disappeared.
5. Press the [B/E] key to return to previous menu or press and hold the [B/E] key for 3 seconds to
exit the menu mode, and return to main screen.

9.9.5.- Scan mode:

Once receives a scanned signal, the transceiver will stop scanning and resume scanning according
the preset scan mode.
You select one of the below options:
● TO (Time): Once the transceiver receives a signal while scanning, it will stay into signal for a
preset time. When the time is finished, it will continue to scanning.
● CO (Carrier): Once the transceiver receives a signal while scanning, the scan will stop until the
signal disappears, after 3 seconds will resume the scan.
● SE (Search): Once the transceiver receives a signal while scanning, the scan turns OFF until you
manually re-activate again.
Procedure:
● Press and hold the [PTT/CTRL] key for 3 seconds to select the currently operation band (CTRL).
● Press the [MENU] knob, and then press the [VOL/SCAN] key.
Also you can program it by means settings menu as below:
1. Press and hold the [PTT/CTRL] key for 3 seconds to select the currently operation band (CTRL).
2. Press the [MENU] knob to access menu list.
3. Rotate the [MENU] knob to select the scan option, and then press it to confirm.
4. Rotate the [MENU] knob to select the scan mode and then press it to confirm.
5. Rotate the [MENU] knob to select TO/SE/CO, and then press it to confirm.
6. "Saved" will display on the screen, and back to previous menu.
7. Press the [B/E] key to back to previous menu or press and hold this key for 3 seconds to exit the
menu mode and return to main screen.

9.9.6.- Scan list:

Users can preset scan list. The transceiver will scan cyclically to check if there is a valid signal on
the scan list channel.
This transceiver can store a maximum of 255 channels.
If it is configured by your salesperson, the users can edit, add, delete channel or choose thr priority
channels through the screen menu.

9.9.7.- Scan list operation:

1. Press and hold the [PTT/CTRL] key for 3 seconds to select the currently operation band (CTRL).
2. Press the [MENU] knob to access into menu list.
3. Rotate the [MENU] knob to select the scan option, and then press it to confirm.
4. Rotate the [MENU] knob to select "Check scan list", and then press it to confirm.
The screen will display the total channel number for current scan list.
5. Rotate the [MENU] knob to check the current list.
English - 35 -