Ingeteam
5. Deferred charge in INGEREV CITY Duo
Charging can be programmed or deferred from most modern electric vehicles themselves.
It is recommended to use this feature whenever available.
However, attending to vehicles that do not feature programmed or deferred charging, it is possible
to configure said deferred charge from this charging point in the most versatile and flexible manner
possible.
However, the manufacturer is not responsible for the compatibility of the programmed or deferred
charge with all vehicles, as some models enter standby mode after a specified period of downtime
and can sometimes fail to react to a signal to charge from the charging point.
In such cases, consult with the manufacturer of your vehicle the time limit that the vehicle must
remain on standby before activating the deferred charge, or learn by trial and error.
As previously mentioned, you can perform deferred charges in these stations as long as it is configured and enabled
for ID cards in which a deferred charge is programmed.
To activate it, configure the start_deferred_charge line and/or the finish_deferred_charge line, or enable the
deferred charge via the ID card. Below we explain the operating modes for both options (without an ID card and
with an ID card).
If you have a deferred charge activated via the charging stations configuration and the user ID card,
the user´s card has priority.
Deferred charge mode is a generic name, because depending on the different configuration possibilities, there are
up to three different modes of deferred charge. They are as follows:
•
Programmed charge start.
•
Programmed charge interval.
•
Programmed charge end.
5.1. Deferred charge by configuration
If the deferred charging option is not enabled on the ID card, there are two possible situations:
1º -
start_deferred_charge, disabled (by default)
finish_deferred_charge, enabled (by default)
The charge begins when the vehicle sends the start charge signal, either immediately or
deferred.
2º -
start_deferred_charge, enabled
finish_deferred_charge, disabled
The station allows charging to take place when the start time is reached and the session
continues indefinitely until the charging is complete.
If the time programmed is 23:00:00 and the user connects the vehicle at 23:00:01, the vehicle
will not start charging until 23:00:00 the following day.
3º -
start_deferred_charge, enabled
finish_deferred_charge, enabled
The station allows charging to take place when the start time is reached and stops charging
at the programmed end time. If the charging is programmed to start at 23:00:00 and end at
09:00:00, if the user arrives at 23:05:00, because this time is within the charge interval the
vehicle will begin charging and will end at the programmed time.
4º -
start_deferred_charge, disabled
14
Deferred charge in INGEREV CITY Duo
ABA2020IQM05_A - Configuration