Attaching The Optional Mounting Flange To The Beacon; Table 2 Mounting Kit Hardware For Permanent Mounted Beacons - Federal Signal Spire 100 Beacon Manual De Instrucciones

Installation and Maintenance Instructions

Table 2 Mounting kit hardware for permanent mounted beacons

Qty.
Basic parts included with permanent mount beacons
3
3
1
1
2
1
1
Additional parts included with mounting flanges
3
3
3
Attaching the Optional Mounting Flange to the
Beacon
If the optional mounting flanges are to be used, you can either
attach them to the beacon before installation or attach the
flange to the vehicle first. If desired, permanently lock the flange
to the base using the three #8 screws provided. See Figure 2.
DO NOT DRIVE WITHOUT FIRST MOUNTING THE BEACON TO
THE FLANGE: Because vehicle roof construction and driving
conditions vary, do not drive a vehicle if the beacon is not
attached to the flange. The beacon could fly off the vehicle,
causing injury or damage. Repair of damage incurred because of
ignoring this warning shall be the sole responsibility of the user.
To attach the mounting flange:
1. Locate the detent on the beacon and one of the two detent
notches on the flange.
2. Align the beacon as shown in Figure 1.
3. Push the beacon down completely and turn clockwise 1/8
turn until the detent locks in place.
8
Description
#8 Panhead Phillips Screw
#10 Panhead Phillips Screw
Terminated Power Wire, 18 AWG, red
Terminated Power Wire, 18 AWG, black
Terminal Contacts
Waterproof Connector Shell
Locking Wedge
#10 Machine Screws, 1-3/4" long
#10 Machine Screws, 7/8" long
#10 Machine Nuts
Spire
Federal Signal www.fedsig.com
100 Beacon
®