Jotul F 360 Serie Manual Del Usuario página 14

ENGLISH
Jøtul F 369 - with three legs
NB! If connecting the flex hose through a hole in the floor, do not
knock out the removable cover plates.
Fig. 21 - a
Fig. 21 - b
1. If connecting a flex hose (Ø 100 mm) for external air supply
to the external air vent (fig. 21 - b) beneath the burn chamber,
first drill a hole (fig. 21 a - A) in the removable cover plates
before they are knocked out. NB! Place the parts on a suitable
surface before the cover plates are knocked out.
Fig. 22
2. The accompanying heat shield should be used to protect the
base from the heat radiating from the product (fig. 22 A).
Secure this first with a screw (fig. 22 B).
3. Secure the brace (fig. 22 C) loosely into place with a screw
(fig. 22 D).
4. Attach the base to the burn chamber using the 4 screws (M8
x 30 mm) from the bag of screws (fig. 4 A).
14
5. Screw the legs together at the back edge using 2 screws that
are in the screw holes (fig. 22 E).
6. Secure the brace (fig. 22 C) into place with a screw (fig. 22 F)
and nut at both ends.
7. Get assistance, protect the flooring from scratches and marks
and carefully raise the stove.
8. Level the product using the 4 adjustment screws (fig. 22 G).
9. If the legs are not properly aligned, loosen the screws (fig. 22 F)
on each side. Adjust the legs and tighten the screws again.
10. Tighten the screw (fig. 22 D).
11. Pull the flex hose through the hole and attach it to the outlet
using a hose clip. NB! Make sure the hose is long enough so
that joints are not necessary.
Fig. 23
12. Place the cover (fig. 23 A) into place. Make sure that the pin
(protrusion) B is facing down.