Basic Functions; Procedure De Secours - Cobra GLOBE 3800 Manual Usuario

4 - BASIC FUNCTIONS

4.1 - Introduction
As the standard working features of this system can be modified by the installer he should have indicated the differences with
the standard factory set-up (black squares) on this manual.
4.2 - Buzzer
If activated the buzzer will sound in synchronism with the
turn indicators to signal the arm and disarm of the system.
4.3 - Doors/bonnet/boot opened signal
If the doors, bonnet or boot are opened when you arm the
system, the turn indicators will blink 5 times. The buzzer will
do the same, if activated. If they are closed within 40 s their
subsequent opening will be signalled again; after the 40 s set
up delay there is no further trigger until they are closed and
opened again.
4.4 - Arm/disarm blinker
The arming of the system is indicated by 2 blinks of the turn
indicators and disarm by 1 blink. If this function is deactivated,
the turn indicators will only blink during an alarm trigger.
26
06DE2085A.pmd 19
4.5 - Automatic arming
The system will automatically arm 2 min. after the ignition is
switched off and the last door closes, but the doors will not
automatically lock. The system will not auto arm if the ignition
is switched on within 2 min..
4.6 - Immobilizer automatic arming
The engine immobilization will automatically activate 4 min.
after the ignition is switched off. The LED will flash. The
engine will be immobilized. Close and open the doors with the
radio control to deactivate the system.
4.7 - Immobilizer alarm
An alarm function can be added to the immobilizer automatic
arming. 25 s after the ignition is switched ON the alarm will
trigger.
4 - BASE FUNCTIONS GLOBE 3800

7 - PROCEDURE DE SECOURS

Pour désactiver le système sans utiliser la radiocommande, procédez de la manière suivante :
appuyez sur le bouton qui se trouve sur le panneau de secours un nombre de fois correspondant au premier chiffre de votre
code PIN.
A chaque pression de la touche correspond un clignotement rapide de la LED. Une pause plus longue sera interprétée par le
système comme la fin de l'enregistrement du chiffre, signalée à son tour par un clignotement long de la LED. Continuez avec
cette procédure pour tous les autres chiffres.
Après avoir terminé l'opération de saisie des chiffres, si le code est correct le système se désactive.
Appuyez un nombre de fois
correspondant au premier
chiffre de votre code PIN.
Clignote-
ment bref
GLOBE 3800 7 - PROCEDURE DE SECOURS
17/01/2005, 14.40
Clignote-
ment long
19