Analyze Sample; Basic Mode - J.P. SELECTA UV2005 Manual De Instrucciones

INSTRUCTION MANUAL CODE 80243 REV A
Figure 7
Figure 8
J
.P. SELECTA s.a.
January/11

6 Analyze Sample

We provide three test methods, which are basic mode test, quantitative mode and
kinetics mode.

6.1 Basic Mode

Push the blank cuvette into the light path. In the main menu (the last one of Fig. 3),
move the cursor onto "Basic mode" and then press [ENTER] to go into basic mode test.
After automatically blanking, it will display as the upper one of Fig. 4 and wait for
the operator.
Press [RETURN] to exit.
Select Test Mode
You can select between three test modes (T%, Abs, Conc. / factor) by pressing [SET]
to make choice.
Use [»] and [«] to move the cursor on Abs., then press [ENTER]. If the icon ""
appears at the end of Abs., you have selected successfully. Press [RETURN] to exit
to the upper screen of Fig. 4, blank at the same time. (Fig. 7)
The operation to select T% mode and Energy mode, is the same as Abs test mode.
Begin to Test
Push the sample into light path, press [START] to go into basic mode test
screen (Fig. 8).
Press [START] again, the test result will be displayed on the screen. The operation
is the same if you change your samples.
Note:
1. Five groups of test data can be displayed per screen, a total of 200 groups of data
can be saved.
2. In the lower one of Fig. 8, you can change your test wavelength, blank, change test
mode and print by pressing: [GOTO], [ZERO], [SET] and [PRINT] respectively.
You can also clear the test data by pressing [CLEAR].
6.2 Quantitative Mode
It includes two test methods: Standard curve and Coefficient method.
In the former method, you can establish a standard curve using standard samples
known concentration.
If you know a curve equation, you can select the latter method.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
(It can be modified without notice)
Tel 34 93 770 08 77 Fax 34 93 770 23 62
Page: 37