Quantitative Mode - J.P. SELECTA UV2005 Manual De Instrucciones

MANUAL DE INSTRUCCIONES CODIGO 80243 REV A
Figure 9
Figure 11
J
.P. SELECTA s.a.
Enero /11
Enter Quantitative Mode
Move the cursor onto the Quantitative Mode, and press [ENTER] to go into the
method choosing interface (Fig. 9).
2-1. Standard Curve Method
It's a method to establish a standard curve by measuring a group of standard samples.
Move the cursor onto the Standard Curve, then press [ENTER], and it will go into
the pre-testing interface (Fig.10).
Set Wavelength
Press [GOTO] in the pre-testing interface, input the testing wavelength by pressing
the numeric keypad (Fig.11).
Blank
Pull the blank solution in the light path, and then press [ZERO].
Set Parameters
Press [SET] in the pre-testing interface. It goes into parameters setting interface
(Fig.12). You should set Unit, the Number of standard samples, and Concentration
of standard samples before testing.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
(Sujetas a modificaciones sin previo aviso) Pag.: 38
Tel 34 93 770 08 77 Fax 34 93 770 23 62