ProRestore Electro-Gen Manual Del Usuario página 3

OPERATING PRINCIPLES
OF THE ELECTRO-GEN™
FOGGER
The ELECTRO-GEN UNIT is a dual purpose chemical application device: A
THERMAL FOGGER which produces a very small size droplet particle and an
optional electric sprayer which produces a cold mist spray similar to that
produced by an aerosol can.
Cold spraying mode
At the touch of the trigger, an electric pump draws solution from the solution
reservoir. The solution is pressurized and forced through a specially restricted
orifice where the solution is atomized into a cold mist.
In the cold spraying mode the operator has a choice of utilizing water based
or solvent based formulations, such as fabric protectors, deodorants, flame
retardants, spotters, insecticides, etc.
Special Advisory
The use of resinous materials such as duct sealants, etc. may clog and
damage the unit and are to be avoided.
Thermal fogging mode
At the touch of the trigger, an electric pump forces solution drawn from the solution
reservoir through an atomizing nozzle and into a thermostatically controlled
heating chamber in the barrel. The solution is vaporized instantly and a cloud of
smoke-like fog surges out of the end of the barrel.
Application Advisory
For odor removal applications always utilize ODORx® Thermo-55™. ODORx
Thermo-55 is ready-to-use and should not be diluted with water. For pest
control applications be sure insecticide label permits THERMAL FOGGING.
For best results dry fog is recommended. The dryer the fog the smaller the
droplets, resulting in improved penetration and economical treatment.
Dryness of the fog is controlled by the rate of solution passing through the
heating chamber. This flow rate is controlled by turning the adjustment knob
clockwise for a dryer fog, and counterclockwise for a damper fog.
10225901E 2 Legend Brands, Inc.