ProRestore Electro-Gen Manual Del Usuario página 6

and insecticides. Wettable powders and resinous materials such as DUCT
SEALANTS are not recommended as they will clog pumping mechanism.
2. Attach chemical reservoir and pull trigger to prime unit and spray.
Thermal fogging
With the fogger unplugged, attach the heat barrel by positioning the two prongs
directly in line with the slots provided for them in front of the housing. Push the
barrel firmly...straight into place, being careful not to twist or bend the prongs.
1. Allow the fogger to pre-heat for at least two minutes before operation.
2. Carry the fogger as you would a suitcase, holding it about three feet off
the ground and away from your side.
3. Pull the trigger located on the underside of the handle, to start unit
operating. Release trigger to stop unit.
4. Turn adjustment knob clockwise to obtain a dry fog. With the proper fog
setting, you shouldn't see moisture on an 8" x 12" (20cm x 30cm) minimum
piece of paper or cardboard when passed through the fog about a foot out
from the barrel. To avoid burns, be careful not to place hand in front of the
barrel.
Electrical source
1. Plug the Electro-Gen into a proper grounded electrical outlet (voltage is
indicated on fogger housing).
2. Extension cords must be 3 wire, 10, 12, or 14 gauge. Long lengths of
lighter gauge electrical cord will not conduct the necessary current
to the heating chamber, and may result in insufficient heating and
solution dripping or leaking from the outer end of the heat barrel. Over
heating of the extension cord may also occur.
Pest control tips
Follow the label instructions: It is a violation of Federal Law to apply an
insecticide in a manner inconsistent with its labeling.
If you wish to thermally fog an insecticide, the product label must state
that the product is suitable for thermal fogging.
If you wish to spray an insecticide indoors, the product must state the
product may be utilized indoors.
10225901E 5 Legend Brands, Inc.