Serial Interface; Connect The Balance To A Printer - Gram RZ Serie Manual De Utilización

to normal weighing mode. If need to exit without clearing data and return to normal
weighing mode, press the
INITIALIZATION OF THE SCALE TO PRINTER (Optional)
1. Press the
and to shift to P09 parameter.
2. Press key to enter the external device setting. Press
choose the printer model.
3. After choosing one printer model, press the
or "INIT?"
• "UNSUP" means the printer can´t be initialized by scale. Press the
• "INIT" means the printer is should be initialized. Press the
printer. When the initialization is finished, the display will show the message "ok" and
then displays the printer model. Press the
Input commands
Connect the scale to computer. Run serial port debugging program on the computer. Input
the capital number "Z", "T", "R", "C", "P" in the sending area and the indicator can conduct
the corresponding actions:
Z = Zero
T = Tare
C = Cancel Tare
R/P = Reading / Print

SERIAL INTERFACE

If external interface is needed, please select proper RS-232 board and only when this board
is adopted, the functions can be enabled.
Note: RTC Is unavailable.
key.
key while powering on to enter parameter setting. Use the
or
key and the display will show "UNSUP"
key to initialize the
key to return.
keys to
key to return.
15