Deleting All User And Master Fingers (Only On-Wall/In-Wall Version); Deleting All User And Master Finger; (Remote Control) - BKS B-55600-20-1-8 Manual De Instrucciones Y De Montaje

Installation and operating instructions
B-55600-20-1-8 | B-55600-20-4-8 | B-55600-23-1-8 | B-55600-23-4-8
Fingerprint scanner and code keypad
6.6.1 Deleting all user and master fingers
You can restore the factory settings by deleting all finger data at the in-wall
or on-wall version of the inside unit. To do this, press the "Delete" button
until the red LED lights up. The device is subsequently in the delivery
condition (red , green and blue LEDs light up continuously).
NOTE
6.6.2 Deleting all user and master fingers
Alternatively, the fingerprint module can be reset via the remote control
provided. This deletes all finger data that have been saved.
Hold the remote control directly in front of the blue LED of the module.
Press the button DA » CODE » OK in this sequence to trigger the reset.
For the factory code, refer to page 50 of this manual. The factory code can
also be found on an adhesive label on the back of the remote control. If you
have assigned a separate master code, then this must be used.
The device is subsequently in the delivery condition (red , green and blue
LEDs light up continuously).
NOTE
EN
74
(only on-wall/in-wall version)
After a reset, any modified master code is reset to
the factory code.

(remote control)

After a reset, any modified master code is reset to
the factory code.
07.2017 | XX | Designed in Germany