Abicor Binzel ABIROB A Instructivo De Servicio página 43

iSTM
11 Dismounting
Dismounting may only be carried out by specialized personnel. Please make
sure that the shutdown procedures are strictly observed, before the dismounting
work begins. Observe it also for the components integrated into the welding
system.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power source.
• Close off the compressed air supply.
• Switch off the entire welding system.
• Pull the mains plug.
NOTE
• Observe the information given in section
 8 Putting out of operation on page EN-16.
1 Disconnect the cable assembly from the wire feeder.
2 Open the lock ring, unscrew the fastening screw.
 6.2.2 Mounting the cable assembly on the robot on page EN-11
3 Pull out the cable assembly.
4 Disconnect the torch neck and remove it.
 6.3 Attaching the ABIROB
 6.4 Attaching the ABIROB
5 Dismount the iSTM from the robot.
 6.1 Fastening the iSTM to the robot on page EN-9
®
A torch neck on page EN-13
®
W torch neck on page EN-14
11 Dismounting
EN - 21