Ferm BGM1003 Traducción Del Manual Original página 8

EN
• To switch off the machine the same switch
needs to be pressed to position '0'.
• Always keep the mains cable away from
moving parts.
• There is no need to apply any pressure with
the workpiece, because this only slows down
the speed of the sanding disc.
Sanding
The sanding belt and disc supplied with this
sanding machine are suitable for the sanding of
metal, wood or synthetic surfaces. The workpiece
should always be held firmly during sanding. No
extra pressure is needed. Guide the work piece
up and down over the sanding belt, in order to
prevent the sanding belt and plate from wearing
through in one place. Round objects can be
sanded at the ends of the sanding belt. Work
pieces which are longer than the sanding machine
can be sanded by removing the fence.
NB: To prevent splintering, wood always needs
to be sanded in the longitudinal direction of the
grain.
To treat a very soft surface, there is a very handy
method to 'bring the particles to the surface'.
This is done as follows: wet the already sanded
surface with a cloth or sponge and let it dry well.
Some wood fibres will swell up more than others,
which leads to a rougher surface than before.
Now the higher particles are treated with fine
sanding paper, the result is a remarkably smooth
surface. This method should not be applied with
varnished wood, however, because the varnish
may come loose because of the moisture.
5. Maintenance
Make sure that the machine is not live
when carrying out maintenance work on
the motor.
The Ferm machines have been designed to
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory
operation depends upon proper machine care and
regular cleaning.
Malfunction
Below we have listed a number of possible
causes and corresponding solutions in case the
machine does not function as it should:
8
The electromotor gets hot
• The cool ventilation slots in the motor are
stopped up with dirt.
• Clean the cool ventilation slots.
• The motor is defective.
• Have your sanding machine repaired /
checked at your local Ferm dealer.
The connected machine does not work.
• Interruption in the mains connection.
• Check mains connection for fracture.
Have your sanding machine repaired /
checked at your local Ferm dealer.
Periodic maintance of the belt sander will
prevent unnecessary problems!
Cleaning
Never use water or other agressive liquids
to clean the machine. Clean the machine by
brushing it with a brush. Keep the ventilation slots
of the machine clean to prevent overheating of the
motor.
Lubrication
There is no need to lubricate the transport rollers
of the machine.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
Environment
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic
waste. According to the European Guideline
2012/19/EU for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must