Installing The Outdoor Unit - York EKKC 12 D Instrucciones De Instalación

by johnson controls
Precautions
1. Incorrect tightening can cause problems,
as shown in Fig. 13.
AIR LEAK
CONDENSED WATER LEAK
AIR LEAK
FROM CEILING
Fig. 13
2. If any clearance is left between the ceiling
and the front panel after tightening,
readjust the height of the indoor unit, as
shown in Fig. 14.
NO CLEARANCE ALLOWED
It is possible to adjust the height of the indoor unit by
tightening at the corners of the front panel if the indoor
unit is level. This does not affect the connections.
* After fastening the unit, make sure there is no
clearance between the unit and the ceiling.
Fig. 14
18
3. Connecting the front panel.
FRONT
INDOOR
PANEL
UNIT
(6) Fasten the 2 front panel connectors to the unit.
Selecting location for the
outdoor unit
- Select a location that satisfies the
following conditions, and those required
by the client.
- Select a location where the air and noise
generated by the unit do not bother the
neighbours.
- Select a very well ventilated location.
- Neither air intake nor discharge can be
obstructed.
- Install in a location that can withstand the
weight and vibration of the unit.
- There can be no danger of inflammable or
corrosive gases.
- Make sure the installation follows the
distances recommended

Installing the outdoor unit

1. Install the unit firmly and in vertical
position, with M10 bolts or greater.
2. Do not install the unit on the roof.
3. To avoid noise, make sure there is
no vibration. To do this, add rubber
washers.
4. Evacuate condensed
appropriate area.
5. Fasten the drain system by means of the
hole inside the outdoor unit.
GB
Fig. 15
water to an
ENJC 12
ENJC 18
ENJC 24, 30
ENJC 36, 42
INDOOR FRONT
UNIT PANEL
D
A
B
A B C D E
776 320 540 510 286
955 396 700 560 360
980 427 790 610 395
1107 440 1100 631 400