Connecting Sear Burner To Grill; Leak Testing - Charmglow 814-6805-0 Manual Del Propietário

• FOR OUTDOOR USE ONLY. DO NOT operate indoors or in an enclosed area such as a garage,
shed or breezeway.
• Use your sear burner OUTDOORS in a well ventilated space away from dwellings or other
buildings to prevent dangers associated with gas accumulation and toxic vapors. We
recommend your sear burner be situated at least 10 feet (3.1 m) from buildings.
• Maintain a minimum clearance of 36 inches (91 cm) between all sides of sear burner and walls
or other combustible material. DO NOT use sear burner under overhead unprotected
combustible construction.
• DO NOT use or install this sear burner in or on a recreational vehicle and/or boat.
FOLLOW THE INSTRUCTIONS FOR CONNECTING YOUR STAINLESS STEEL LP
DROP-IN 4-BURNER GRILL TO THE LP CYLINDER.
These instructions are located in the 810-6805-0 Stainless Steel LP Drop-In 4-Burner Grill owner's manual. After
main grill installation follow the instructions below for connecting your sear burner to the Quick-Disconnect coupler.
Connect the sear burner hose fitting
to the grill body hose by inserting
the fitting into the quick-disconnect
coupler.
• Never use your grill without leak testing all gas connections and hoses. See the section on
"Leak Testing" in this manual for proper procedures.
• Visually inspect the hose assembly prior to each use for evidence of damage, excess wear or
deterioration. If found, replace the assembly before using your grill. Only the Brinkmann
supplied replacement should be used.

LEAK TESTING:

To prevent fire or explosion hazard:
• DO NOT smoke or permit ignition sources in the area while conducting a leak test.
• Perform test OUTDOORS only in a well ventilated area.
• Never perform a leak test with a match or open flame.
• Never perform a leak test while the grill is in use or while grill is still hot.
WARNING
Quick-Disconnect Coupler
WARNING
DANGER
Push sleeve back to attach
Sleeve Sear Burner Hose Fitting
4