Publicidad
Step 12
Fasten three ANGLE BRACKETS (L) to an ADJUSTABLE SHELF (C). Use three
å
BLACK 9/16" LARGE HEAD SCREWS (W).
NOTE: Do not completely tighten the SCREWS at this time.
å
With a scissors, cut out the rectangular spacer at the top of this page and lay it
å
on the corner of an ADJUSTABLE SHELF (C) as shown in the enlarged diagram.
Fasten an ADJUSTABLE SHELF MOLDING (G) to this ADJUSTABLE SHELF (C).
å
Use three BLACK 9/16" LARGE HEAD SCREWS (W). Tighten all six SCREWS in
the ANGLE BRACKETS.
NOTE: Be sure the notched edge of the MOLDING fi ts around
å
the ADJUSTABLE SHELF.
NOTE: There are no pre-drilled holes in the ADJUSTABLE SHELF
å
MOLDING (G). The SCREWS will tighten into the groove.
Repeat this step for the remaining ADJUSTABLE SHELF (C).
å
BLACK 9/16" LARGE HEAD SCREW
(12 used in this step)
Page 16
Cut out this rectangle to use as a
"spacer"
1-11/16"
G
C
W
102792
(6 used)
L
G
L
C
www.sauder.com/services
Publicidad
