Publicidad
Step 13
Insert eight METAL PINS with RUBBER SLEEVES into the
å
hole locations of your choice in the UPPER ENDS (AA). Set
the ADJUSTABLE SHELVES (C) with MOLDINGS (G) onto
the METAL PINS.
Do the ADJUSTABLE SHELF MOLDINGS look too
short? They should measure almost 25 1/8". Try the
tips listed below.
If there is a 3/4" gap between the ADJUSTABLE
SHELF MOLDING and the END MOLDING, then the
END MOLDINGS are on wrong. Refer back to step 6.
If there is a 1/4" gap between the ADJUSTABLE
SHELF MOLDING and the END MOLDINGS, then
adjust the END MOLDINGS in until the gap is closed.
www.sauder.com/services
Adjust the END MOLDING tight
against the SHELF MOLDINGS
by loosening the screws,
closing the 1/4" gap and then
tightening the screws.
AA
G
G
C
102792
C
C
AA
Page 17
Publicidad
