ANGLE BRACKET: BRACKET INSTALLATION
Step 1:
Mark Bracket Hole Locations
1� Mark the centerline of each post with a pencil�
2� Take measurements used in Fig� 1 and 2 to mark bottom and
top bracket hole locations onto posts�
Note:
• Installed panel heights include space between the deck sur-
face and underside of bottom rail�
Fig. 1
Pre-drill Dimensions: Pre-drilling with a 3/16"[4�5mm] drill bit is required
A*
34" [864mm] Panel
4-1/16" [106�5mm]
40" [1016mm] Panel
4-1/16" [106�5mm]
*Dimension A positions bottom edge of rail 3-1/2" [89mm] above deck surface�
*Dimension A is measured from the bottom surface of post base�
Fig. 2
B
Step 2:
Pre-Drill Aluminum Angle Brackets
Tip:
• It's important to double check dimensions to confirm
accuracy of bracket hole locations before drilling.
1� Use Spring Punch to mark the holes� As shown in Fig� 1�
Bracket Hole Locations
36-15/16" [937mm]
42-15/16" [1091mm]
A
C
PURE VIEW: Al
FULL GLASS PANEL INSTALLATION
13
B
A
C
1" [25�5mm]
1" [25�5mm]
19