KTM 64112955044 Instrucciones De Instalación página 11

- Completely remove piston rod
Assembling the fork legs
- Mount bushing (included) on piston rod
- Slide piston rod into the cartridge.
- Mount fl uid barrier all the way up to the stop.
- Slide adapter into the cartridge.
- Mount lock ring .
- Position adapter on lock ring
- Unclamp the cartridge.
- Clamp cartridge vertically.
Clamping block T14015S
- Position spring with preload spacers
The tight coil of the spring is mounted at the bottom.
NOTE
The large 30 mm bushing
- Mount special tool (open end wrench T14032).
- Mount screw cap all the way up to the stop.
- Hold nut and tighten screw cap
- Remove special tool (open end wrench T14032).
.
.
.
and spacer ring
is not reused.
with 30 Nm.
(included).
11