Transmission Drive Belt - Cub Cadet RZT Serie Manual Del Operador

2. Use a 15⁄16" wrench to hold the hex nut on top of the spindle
assembly when loosening the hex nut securing the blade.
A block of wood may be placed between the deck housing
and the cutting edge of the blade to help in breaking loose
the hex nut securing the blade. See Fig. 7-7.
Hex Flange Nut
3. When reinstalling the blades, be sure they are installed so that
the wings are pointing upward toward the top of the deck.
4. Tighten the blade nuts to 70-90 ft. lbs.
5. Reinstall the deck (refer to Deck Installation on page 28).

Transmission Drive Belt

If the transmission drive belt becomes worn and causes the drive
transmissions to slip, the drive belt must be replaced. To replace
the drive belt, proceed as follows:
1. Remove the deck drive belt from the PTO clutch on the bottom
of the engine following the instructions in Deck Removal.
2. From beneath the rear of the tractor, insert a
into the square hole of the drive idler bracket. See Fig. 7-8.
Square Hole
Idler
Bracket
30 s 7— s
ectiOn ervice
Wood Block
Spindle Assembly
Figure 7-7
3⁄8" drive ratchet
Transmission
Drive Pulley
Idler
Pulley
Engine
Idler Bracket
Pulley
Spring
Figure 7-8
3. Using the ratchet for leverage, pivot the idler bracket and idler
pulley away from the backside of the 'V" belt; then lift the belt
off and above the engine pulley and off the idler pulley.
4. With the belt loose, lift the belt off, up and over the two
transmission drive pulleys. Remove the belt from the
engine and idler pulleys.
5. Loop the new belt and slide over and onto the two
transmission pulleys.
6. Route the belt above the idler bracket back to the engine
drive pulley. Lift the belt over the PTO pulley and above the
engine drive pulley.
7. Using the ratchet for leverage, pivot the idler bracket and
idler pulley against the spring tension; then slip the belt
down into the engine drive pulley and onto the idler pulley.
8. Release the idler bracket so that the idler pulley tightens
against the back side of the belt and tensions the drive belt.
9. Reinstall the deck drive belt.
Tractor Creeping
Creeping is the slight forward or backward movement of the
tractor when the engine is running at high idle and the drive
control levers are opened out in the neutral position.
If after operating the tractor for some time, it begins to creep
while in the neutral position, adjust the transmission control rods
as follows.
1. Place the front of the tractor against an immovable object
(e.g. wall, post, etc.).
2. Jack up the rear of the tractor so that both rear wheels are
approximately one inch of the ground.
3. With the engine running at high idle and the drive control
levers opened out in the neutral position, and the parking
brake disengaged, check the rear wheels for rotation.
4. If only one wheel is rotating, locate the transmission
control rod beneath the frame at the front of the rear tire. If
both wheels rotate, locate both control rods. See Fig. 7-9.
RH Transmission
Control Rod
Flange
Lock Nut
Drive
Belt
PTO
Pulley
Hex Screw
Transmission
Control Arm
Figure 7-9