Lapierre Route Manual De Utilización página 38

WARNINg
These set ups are important. Do not hesitate to ask advice from your dealer.
NEVER EXCEED ThE
In order to set up the suspension, the tecnic fS-700 bike has a red lever that must be tightened to slow down,
MAXIMUM PRESSURE
and vice versa.
INDICATED ON ThE USER'S
the tecnic fS-900 bike has a red lever that acts on the rebound system and can also block the shock absorber.
MANUAL OF ThE ShOCk
It also has a small golden stop that enables you to keep the initial set up after blocking the shock absorber. It
ABSORBER. ALWAyS REFER
TO ThAT USER'S MANUAL
is this stop that acts on the initial set up of the rebound and that should be pre-set according to your weight
FOR ANy qUESTION yOU
and riding style.
MAy hAVE OR FOR ANy
for more information, and to know how to maintain your shock, please refer to the user's manual from the
MAINTENANCE MATTERS.
manufacturer, given with your bike.
DO NOT DISASSEMBLE ThE
ShOCk ABSORBER IN ANy
Make sure you never exceed maximal pressures indicated on the shock absorber.
CASE: hIgh AIR PRESSURE
COULD hURT yOU.
IN CASE OF ANy DOUBT OR
qUESTION, DO NOT hESITATE
TO CONTACT yOUR OR ANy
LAPIERRE AUThORIzED
the fPS (full Power Suspension) is based on an equilibrium point, and it is thus necessary to set the pressure
DEALER.
of the shock absorber properly to get the best results. to do so, all fPS2 models are equipped with an indicator
on the swing arm.
SET-UP
Steps to follow :
1- Sit on the bike, with your feet on the pedals and in riding position. (Leaning with your elbow on the wall helps).
2- Once you are balanced, the indicator should point to the equilibrium point:
- If the indicator is pointed between « zero » and « min », you need to reduce the pressure.
- If the indicator is pointed between « zero » and « max », you need to increase the pressure. A high-pressure
pump is recommended for this step.
Warning : Never exceed 200 psi or 14 bars, and do not allow any foreign objects to enter while you are
adjusting.
to check your setting, you can slightly bounce while you are on the saddle and verify that the indicator always
returns to the equilibrium point. You can also ride on flat ground to check that the indicator stays at the
equilibrium point. If you do this, beware of oncoming traffic!
3 FPS2 (X-CONTROL)
III - SPECIFIC MODELS
SPECIFIC MODEL - 13