Changing The Head Angle / Dh 2011; Integrated Seat Post Tightening System - Lapierre Route Manual De Utilización

the AcS plate in direct contact with the teeth of the chainring, studs, etc. However, if the plate is too far away
from the teeth, the chain may get stuck.

7 ChANgINg ThE hEAD ANgLE / Dh 2011

Steps to follow :
1- Remove the eccentric LAPIERRE pressed cup.
2- turn the two cups in the frame ½ a turn to change the head angle, then insert the cups.
3- the mark on the cups will allow to read the angle on the current angle.
Head angles: 63.5° + 0.5° = 64° or 63.5° - 0.5° = 63°
Warning : the two cups must be mounted with the two marks showing the same head angle!
8 INTEgRATED SEAT POST TIghTENINg SySTEM /RAPT 2.1/RAPT 2.2/Dh 2011
completely integrated in the top tube, this tightening system is composed of two biting pieces activated by
an allen/hex bolt. As it presses the seat tube this one stays in the desired place. there is also a significant
reduction on weight and the advantage of avoiding the possibilities of rips or accidents.
Steps to follow :
1- Insert the seat post in the frame.
2- Insert the biting pieces and the bolt as shown in the picture.
3- Standstill the seat post on the desired position and screw the bolt, torque 10-11 Nm.
III - SPECIFIC MODELS
SPECIFIC MODELS - 17