Publicidad
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
Existing weldnuts
Fasteners typical
both sides
Figure 1
Air dam removal or Optional Air dam trim, and Tow Hook removal.
1. Remove 6 hex fasteners that hold the center lower air dam, using a 10mm socket.
2. Air dam may be returned to owner or optional trim, see figure 2.
3. Remove 2 hex bolts per front tow hook and remove front tow hook(s). Return to vehicle owner.
4. If trimming air dam, reinstall trimmed air dam and 6 hex fasteners, using a 10mm socket.
Install Hitch
1. Raise hitch into position.
2. Install with supplied M12 bolts, 1/2'' lock washers and, 7/16'' flat washers as shown in figure 1.
3. Tighten all M12 fasteners with torque wrench to 76Lb.-Ft. (103 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2016 Cequent™ Performance Products, Inc. -
Installation Instructions
PART NUMBERS: 65075, CQT65075
Frame rail
③
②
①
Printed in Mexico
①
②
③
Figure 2
Sheet 3 of 9
65075N
Fastener Kit: 65075F
Qty.(4)
Bolt
M12 X 1.25 X 40mm Cl10.9
Qty. (4)
Lock washer
1/2''
Qty. (4)
Flat washer
7/16''
10-15-16
Rev. A
Publicidad
