To Use The Cutting Technique; To Cut A Trunk That Has Support On One End; To Cut A Trunk On The Ground; To Cut A Trunk That Has Support On Two Ends - Husqvarna 565 Manual Del Usuario

To use the cutting technique

WARNING Use full throttle when you cut
and decrease to idle speed after each cut.
CAUTION Engine damage can occur if the
engine runs for too long at full throttle
without load.
1. Put the trunk on a saw horse or runners.
WARNING Do not cut trunks in a pile.
That increases the risk of kickback and
can result in serious injury or death.
2. Remove the cut pieces from the cutting area.
WARNING Cut pieces in the cutting area
increase the risk of kickback and that
you can not keep your balance.

To cut a trunk on the ground

1. Cut through the trunk on the pull stroke. Keep full
throttle but be prepared for sudden accidents.
WARNING Make sure that the saw chain
does not touch the ground when you
complete the kerf.
140 - 005 - 18.09.2019
2. Cut approximately ⅔ through the trunk and then
stop. Turn the trunk and cut from the opposite side.

To cut a trunk that has support on one end

WARNING Make sure that the trunk does
not break during cutting. Obey the
instructions below.
1. Cut on the push stroke approximately ⅓ through the
trunk.
2. Cut through the trunk on the pull stroke until the two
kerfs touch.

To cut a trunk that has support on two ends

WARNING Make sure that the saw chain
does not get caught in the trunk during
cutting. Obey the instructions below.
1. Cut on the pull stroke approximately ⅓ through the
trunk.
1. 2.
2.
1.
15