Publicidad
Idiomas disponibles
Idiomas disponibles
3/8" Avdelok
®
Nose Assembly 73411-03100 and 73430-03100 for Avlock
®
T10 and Avdel
AV™10
Fitting Instructions
Item numbers in bold refer to nose assembly components in the table and illustration on page 2.
Avlock T10 Tool:
Holding the tool pointing down, screw the assembled collet fully onto the piston rod until it is flush with end of the
collet adaptor.
Insert Collet Lock 7 into Collet 2. Rotate Collet 2 on the piston rod in either direction until Collet Lock 7 slots into
the nearest groove in the collet adaptor. The Collet Lock 7 should be flush with the exterior of Collet 2.
Slide Anvil 1 over the collet and screw into the anvil adaptor until it is firm.
There is a locking 'O' Ring which will create a resistance to the final few turns of the nose casing. It is imperative
that the nose casing be hand tightened up against the rear locking face.
Avdel AV™10 Tool:
The Collet 2 will be supplied pre-assembled with a ball type Collet Lock 7 and not with the loose brass pin type as
illustrated above.
Holding the tool pointing down, screw the assembled Collet 2 onto the piston rod until the Collet Lock 7 lines up
with one of the four counter bores on the piston thread. Rotate Collet 2 on the piston rod in either direction until
Collet Lock 7 slots into the nearest counter bore.
The Collet Lock 7 should be flush with the exterior of Collet 2.
Slide Anvil 1 over Collet 2 and screw into the body of the placing tool until it is firm.
There is a locking O-ring which will create a resistance to the final few turns of the Anvil. It is imperative that the
Anvil be hand tightened up against the rear locking face.
Servicing Instructions
Nose assemblies should be serviced at weekly intervals. You should hold some stock of all internal components of the
nose assembly as they will need regular replacement.
Remove the nose assembly using the reverse procedure to the 'Fitting Instructions'.
Any worn or damaged part should be replaced.
Clean and check wear on Jaw Set 3.
Check that Follower 4, Sleeve 6 and 'O' Rings 5 are not distorted.
Assemble according to the 'Fitting Instructions'.
3
Publicidad
