Plan Your Installation
It is recommended to read through the entire manual before beginning your installation. Follow
all steps exactly. Reading this manual will also help you get all the benefits from your system.
Your Reverse Osmosis Drinking Water System can be installed under a sink or in a remote
location. Typical remote sites are a basement or laundry room or utility room. Review the
location options below and determine where you are going to install your system.
Under the Sink Location
The Reverse Osmosis Filter Assembly and storage tank are normally installed in a kitchen or
bathroom sink cabinet. See Fig. 1.
A suitable drain point is needed for reject water from the Reverse Osmosis Filter.
Remote Location
You can also locate the Reverse Osmosis Filter Assembly and storage tank in a remote
location away from the Reverse Osmosis Faucet. You will need a nearby water source and
drain point. See Fig. 2.
NOTE: Ensure the location is heated. Cold incoming water will adversely affect RO flow rate.
Check Space Requirements
Check size and position of items for proper installation into location chosen.
Overview and Site Preparation
There are eight easy steps to installing your Drinking Water system. They are as follows:
STEP 1: Install Kitchen Faucet Adapter
STEP 2: Install RO Drain Connector
STEP 3: Install RO Filter Assembly
STEP 4: Install Water Storage Tank
STEP 5: Install RO Faucet
STEP 6: Connect Tubing for Water Supply Line from Kitchen Faucet Adapter to RO System Head
STEP 7: Install RO System and Drain in Remote Location
STEP 8: Sanitize, Pressure Test, Purge System
Prepare Site for Installation
1
Before Starting, close the cold water shut-off valves.
2
Temporarily place tank and filter assembly into cabinet. Double
check position of items and space required for proper installation.
3
Remove tank and filter from cabinet and set aside.
NOTE: You must check and comply with all local plumbing codes.
WFRO60X-1
NOTE: DO NOT CONNECT 3/8" RED DRAIN TUBING TO DRAIN WITH A GARBAGE DISPOSAL.
This product will not work without proper installation
RESTRICTOR
ELBOW
FITTING
3
WARNING
of these parts.
V4.5E