Error Messages; Spare Parts; Lid Emergency Opening - Selecta PRESOCLAVE III 50L Manual De Instrucciones

MANUAL DE INSTRUCCIONES
20
J
.P. SELECTA s.a.u.
CODIGO 80350 REV B

9 Error messages

Error 1 Pressure sensor failure or overpressure.
Error 2 PT100 probe failure or overtemp.
Error 3 External alarm. Pressure switch or safety thermostat trigered.
To reset the safety thermostat, press its button num-
ber 20.
The thermostat is adjusted in the factory, it must not be
operated except to reset it.
Error 4 Open door interlocking during the cycle.
Error 5 Open door during a cycle.
Error 6 Pressure over +0.05bar with the autoclave stopped.
Error 7 E2PROM failure.
Error 8 Out of limits temperature during sterilization.
Error 9 Mains supply failure during cycle.

10 Spare parts

07292 RS-232 communication wire
07315 26 pins communication wire
10044 R4 closing
13006 Contactor
15410 Fuse 16 A
16055 Solenoid electromagnet
16057 Electrovalve NA 3 mm 24 V
16212 Pressure switch
20096 Bipolar switch
29358 Frontal circuit
29459 Power circuit
36027 Solid relay 25A
39001 Heating element 2800W/230V
43031 Thermostat
43071 Pt100 probe

11 Lid emergency opening

In case of power supply failure, it is possible to open the lid manually.
Attention: Before opening the cover by using this system, make
sure that the gauge pressure is 0 bar.
Remove the top drawer from the display by pulling hard (it is not screwed
down, but snapped). A yellow cap will appear, gently pull it until you
hear a click. The closure will be opened.
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
FEBRERO 2020
Tel 34 937 700 877 Fax 34 937 702 362
Pag.: 26