Installation; Location; Reversing The Door Swing - DAKO RDC210NEWWY0 Manual Del Propietário

R
EFRIGERATOR

Installation

Location

When selecting a position for your
unit you should make sure the floor
is flat and firm, and the room is well
ventilated. Avoid locating your unit
near a heat source, e.g. cooker,
boiler or radiator. Also avoid direct
sunlight as it may increase the elec-
trical consumption. Extreme cold am-
bient temperatures may also cause
the unit not to perform properly.

Reversing the door swing

Tools Required:
• Phillips screwdriver
• Flat blade screwdriver
• Wrench
1. Remove the right top hinge cover.
2. Remove the screws holding the top hinge using a cross slot screw-
driver.
This unit is not designed for use in a
garage or outdoor installation.
Do not drape the unit with any cover-
ing.
When installing the unit, make sure
that 10 cm of free space is left at
both sides, 10 cm to the back and 30
cm to the top of the unit. This will al-
low fresh air to circulate around the
unit and improve the efficiency of the
cooling process.
Right top hinge
cover
Two screws
20