Use; Procedure For Use; Unscrew Button - Rebel BTR170 Manual De Instrucciones

3 - Use

The device can be used in all positions, held in hand or suspended.

Procedure for use

• Install the battery
• Switch the device on, by pulling the main trigger
• Position the insert on the mandrel. A light pressure starts the motor and causes the
automatic screwing of the insert, then its shutdown (Push-Pull system). Then insert the insert into
the hole.
• Alternatively, insert the insert intothe hole, then push the mandrel against it in order
to activate the push-pull.
• Press the trigger and hold it until the mandrel has unscrewed from the thread.
KEEP THE TRIGGER PULLED FOR THE ENTIRE DURATION OF THE CYCLE. IF THE TRIGGER IS
RELEASED, THE INSERTION WILL NOT BE CORRECT
Push pull (automatic)

Unscrew button

• If the automatic unscrewing is difficult, use the CENTER (UNSCREW / RESET) button.
To unscrew, hold the button down until the mandrel has fully unscrewed from the insert thread.
Insert Crimp Spin off (automatic)
39