Programming Menu - Rebel BTR170 Manual De Instrucciones

Programming menu

The display screen appears after start up as in the picture below:
Battery load level (%)
Access to the menu pages
Press the LEFT (MENU) button for 2 seconds to enter the programming menu. The LEFT button moves
the selection UP, the RIGHT button moves it DOWN, the CENTER button CONFIRMS.
The screen shows the main menu. Selectable options are:
1. Language
I
Select the display language. Available options are French, English,
German, Italian, Spanish, Portuguese.
2. Part counter
I
Displays and allows the resetting the part cycle counter. Reset is
done by pushing LEFT and RIGHT buttons at the same time.
3. Switch OFF time
I
Select the time after which the tool switches off, if no operation is
performed or no button is pressed (available options: 1, 5 or 10
minutes). In order to switch it on again, pull the trigger briefly. This
time affects battery life.
40
Manual command for the
unscrewing / Reset button in case of fault
Information
of screwing state
Setting force level (in kN)
Access to the setting
force adjustment screen