Care And Cleaning - Kohler K-1188BR Guia Del Propietario

Operating Instructions (cont.)
After approximately 20 minutes of continuous operation, a built-in timer will automatically stop the
pump/motor.
Chromatherapy Light Operation
If the chromatherapy lights are turned off, press the light control switch (located opposite of the
pump control switch). The chromatherapy lights will begin to cycle through each of the colors
(sweep mode). The light control switch flashes blue in the sweep mode.
If desired, press the light control switch to lock in one constant color. The light control switch is a
constant blue in this mode.
Press the light control button to turn the chromatherapy lights off.

Care and Cleaning

For best results, keep the following in mind when caring for your KOHLER product:
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
For detailed cleaning information and products to consider, contact the KOHLER Customer Care Center at
0-800-4-KOHLER (0-800-4-4537) or visit www.kohler.com.br.
Flush System
NOTE: Flush your whirlpool system twice a month or more, depending upon usage.
Make sure the metal suction screen is clean and placed correctly over the plastic suction cover.
Fill the bathing well with hot water so the bathing well overflows the bathing well rim and flows
into the overflow channel to the drain overflow, and so both overflow channel sensors are
completely covered with water. The green light in the pump control switch will start to blink
automatically within 30 seconds after the overflow channel sensors are completely submerged.
Add 10 mL of a low-foaming dishwasher detergent, and 590 mL (20 ounces) of household bleach to
the water.
Press the pump control switch button, and let the unit run for 5 to 10 minutes.
Press the pump control switch button a second time to turn off the unit.
Completely drain the unit.
Wipe the surface dry with a clean, soft cloth.
Troubleshooting
NOTICE: This section is for general aid only. A Kohler Co. Authorized Service Representative or
qualified electrician should correct any electrical problems. For warranty service, call 0-800-4-KOHLER.
NOTE: The product model number is printed on a label on the pump side of the whirlpool.
NOTE: For service parts information, visit your product page at www.kohler.com.br.
1019731-BR5-A
English-4
Kohler Co.