Kohler K-9607-R Guia De Instalacion página 13

Troubleshooting (cont.)
Problem
1. Water and steam
spits from spout
and the dispenser
faucet has not
been turned on.
2. Water is not hot.
3. Water is too hot or
not hot enough.
4. Water comes out
of the vent instead
of the spout.
Kohler Co.
Possible Cause What to do
A. Water in the unit a.
is boiling. This
may be normal
during initial setup.
b. Adjust the water
A. The unit may not a.
be plugged in.
B. There is no b. Reset the circuit
electricity.
c.
A. Water temperature a.
is not properly
adjusted.
A. The outlet tube is a.
blocked.
b. Remove the spout
13
Depress the faucet
lever to release
some water from
the tank.
temperature using
the dial. (See the
"Adjust the Water
Temperature"
section.)
Remember that at
higher altitudes,
water boils at a
lower
temperature.
Make sure that the
outlet is properly
grounded.
breaker or replace
the fuses.
Make sure that the
outlet is on.
Adjust the water
temperature using
the dial. (See the
"Adjust the Water
Temperature"
section.)
Make sure that the
outlet tube is not
kinked, twisted, or
pinched.
end piece and
clean out all
debris.
112114-2-BE