Kohler K-9607-R Guia De Instalacion página 6

1-5/8" (4.1 cm)
Stainless Steel
Washer
1-5/8" (4.1 cm)
Rubber Washer
3. Install the Dispenser
CAUTION: Risk of product or property damage. Twisted,
pinched or blocked tubes may cause excess pressure and damage
the dispenser tank.
Carefully straighten the dispenser tubes.
Remove the plastic wing nut from the faucet body.
Slide the stainless steel washer(s), followed by the rubber washer,
over the dispenser tubes and up against the faucet body.
Place the assembly through the faucet hole.
NOTE: Have someone hold the dispenser in the final installation
position while performing the following steps:
From under the sink, slide the 2-1/4" (5.7 cm) fiber washer over
the dispenser tubes.
Thread the wing nut onto the faucet body and hand tighten. Do
not overtighten.
112114-2-BE
1-5/8" (4.1 cm)
Stainless Steel
Shroud
Washer
Setscrew
1-5/8"
Counter Top
(4.1 cm)
13/16"
Rubber
(2.1 cm) Max
Washer
2-1/4"
(5.7 cm)
Fiber Washer
6
Wing Nut
Kohler Co.