Best WBF4I Manual De Instrucciones página 12

INSTALL THE HOOD
(Vertically Ducted Hoods Only)
1. DO NOT REMOVE the protective
plastic film covering the decorative
flue and the hood at this time.
2. Lay the back side of the hood
flat on a table. Use a piece of
cardboard to avoid damaging the
table or the hood.
3. Attach damper / duct connector to
top of hood using (4) #8 x 3/8" Pan
Head mounting screws.
4. Remove the grease filters by pushing down the metal latch tab and tilting
filters downward to remove.
5. Carefully rotate hood upright.
6. Remove the upper flue from inside
the lower flue. Install the lower
flue bracket to the lower flue using
(2) flue bracket screws #8 x 3/8",
make sure that the slots are at the
top. Carefully replace the upper
flue inside the lower flue, with the
upper flue recirculation slots and
(2) bracket holes on top. Remove
protective plastic film covering the
lower flue only.
7. Carefully place both flues on top of
hood.
Tabs on bottom edge of lower flue
fit into slots on top of hood.
8. Measure and install
metal ductwork to hood
duct connector. Use duct
tape to make all joints
secure and air tight.
9. Hold hood up close to
wall mounting location
and plug power cord into
wall outlet.
10. Align the hood and
center it above the
hood mounting bracket. Make sure ductwork on hood lines up and attaches
to ductwork in ceiling. Gently lower the hood until it securely engages the
bracket.
11. Use duct tape to make all joints secure and air tight.
(4) #8 X 3/8"
PAN HEAD
SHEET METAL
SCREWS
LOWER FLUE MOUNTING BRACKET
6" ROUND
STEEL DUCT
DUCT LENGTH
DECORATIVE
FLUE
- 12 -
DAMPER / DUCT
CONNECTOR
LOWER
FLUE