Best WBF4I Manual De Instrucciones página 13

12. With the hood hanging
in place, drill through
both holes located
in the inside lower
back of hood using
a 5 ⁄ 1 6" drill bit. Insert
the included drywall
anchors into the
drilled holes (one for
each hole). Install (2)
washers and (2) #8
x 1-1/2" mounting
screws through the
hood back and into
the drywall anchors.
Verify that the hood is
centered and leveled. Tighten all screws completely.
13. Reinstall grease filters by aligning rear filter tabs with slots in the hood.
Push down the metal latch tab, push filter into position and release. Make
sure filters are securely engaged after installation.
14. Slightly push aside the upper flue to avoid any damage while installing the
lower flue to the hood top using (2) #8 x 3/8" screws through the lower flue
side slots.
15. Slide the upper flue upward until it
is aligned with its mounting
bracket. The bracket should be
inside the flue. Secure the upper
flue to the upper flue mounting
bracket using (2)
#8 x 3/8" mounting screws.
16. Remove protective plastic film
covering the upper flue and the
hood.
I
NSIDE BACK
OF THE HOOD
S
IDE VIEW
H
OLES LOCATION
UPPER FLUE MOUNTING BRACKET
- 13 -
M /B
OTOR
ASSEMBLY
Ø5/16"
FRONT VIEW
UPPER
FLUE
LOWER
.
TYP