Grounding Instructions - Best WBF4I Manual De Instrucciones

INSTALL THE DUCTWORK (Ducted Hoods Only)
NOTE: To reduce the risk of fire, use
only metal ductwork.
1. Decide where the ductwork will run
between the hood and the outside.
2. A straight, short duct run will allow
the hood to perform most efficiently.
3. Long duct runs, elbows, and
transitions will reduce the
performance of the hood. Use as
few of them as possible. Larger
ducting may be required for best
performance with longer duct runs.
4. Install a roof or wall cap. Connect
round metal ductwork to cap and work back towards hood location. Use duct
tape to seal the joints between ductwork sections.
INSTALL THE WIRING

1. GROUNDING INSTRUCTIONS

This appliance must be grounded.
In the event of an electrical short
circuit, grounding reduces the risk
of electric shock by providing an
escape wire for the electric current.
This appliance is equipped with a
cord having a grounding wire with
a grounding plug. The plug must
be plugged into an outlet that is
properly installed and grounded.
2. Position the electrical outlet
within the space covered by the
decorative flue and where it will not
interfere with the round duct. Make
sure the outlet is no further than
11½" from where the cord exits from the hood and that the outlet does not
interfere with a mounting bracket fastening area or where the decorative flue
touches the wall.
ROOF CAP
DECORATIVE
FLUE
HOOD
24" TO 30" ABOVE
COOKING SURFACE
- 6 -
6" ROUND
DUCT
WALL
CAP
6" ROUND
ELBOW
DAMPER /
DUCT
CONNECTOR
1 1 ½ "
M A X .