Safety Notes; General Notes; Functions - Trix 03.10 Serie Manual De Instrucciones

Safety Notes

• This locomotive is to be used only with an operating
system designed for it.
• Use only switched mode power supply units and trans-
formers that are designed for your local power system.
• This locomotive must never be supplied with power from
more than one power pack.
• Pay close attention to the safety notes in the instructions
for your operating system.
• Do not expose the model to direct sunlight, extreme
changes in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
• The feeder track must be equipped to prevent interfer-
ence with radio and television reception, when the
locomotive is to be run in conventional operation. The
611 655 interference suppression set is to be used for this
purpose. The interference suppression set is not suitable
for digital operation.

General Notes

• The operating instructions and the packaging are a com-
ponent part of the product and must therefore be kept as
well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or
spare parts.
• http://www.maerklin.com/en/imprint.html

Functions

• Built-in electronic circuit for operation with a convention-
al DC power pack (max. ±12 volts), Trix Systems or NMRA
DCC digital systems.
• Automatic system recognition between digital and analog
operation.
• The full range of functions is only available under
Trix 66950/60214 and under DCC.
• Built-in headlights that change over with the direction of
travel. They can be turned on and off in digital operation.
• Minimum radius for operation is 360 mm / 16-9/16".
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Trix have been installed in Trix
products or where Trix products have been converted in such a way that
the non-Trix parts or the conversion were causal to the defects and / or
damage arising. The burden of presenting evidence and the burden of proof
thereof, that the installation of non-Trix parts or the conversion in or of Trix
products was not causal to the defects and / or damage arising, is borne by
the person and/or company responsible for the installation and / or conver-
sion, or by the customer.
11