Dyna-Glo DGJ810CSB-D Manual De Instrucciones página 22

ASSEMblY INSTRUCTIONS
39. Insert the grease pan (I) into position by sliding
it in the firebox (L) from the rear along the rails.
Insert the grease cup (H) into position by sliding
it onto the rails located on the bottom side of the
grease pan (I).
40. Remove the igniter cap by turning it counter-
clockwise. Insert the AA battery (I1) into the igniter
body with positive (+) end facing out. Replace the
igniter cap.
41. Insert the LP gas cylinder (sold separately) into
the nesting hole located in the tank shelf (R).
Hand-tighten the hose/regulator coupling to the
threaded valve of the LP gas cylinder. Tighten the
tank screw until the cylinder is secure inside the
nesting hole of the tank shelf (R).
39
40
41
22
I
I1
R
L
H