Power On/Off; Video Recording - Wiseup W4000 Manual De Instrucciones

memory has been formatted on your PC computer.

3.1. POWER ON/OFF

3.1.1. Power on the camera by pressing the Power Button for 3 seconds. Both blue and red
indicator lights will be illuminated for 3 seconds and then turn off. The camera will start video
recording automatically.
3.1.2. Power off the camera by pressing the Power Button for 3 seconds again in standby
mode. Both blue and red indicator light will flash once and then turn off.
[Note]:
1). If the camera is running low on batteries, the blue and red indicator light will keep flashing alternately
for 5 seconds and then turn off. The camera will shut down automatically.
2). The camera will shut down automatically if it is in standby mode without any operation more than 3
minutes.

3.2. VIDEO RECORDING

3.2.1. Power on the camera by pressing the Power Button for 3 seconds. Both blue and red
indicator lights will be illuminated for 3 seconds and then turn off. The camera will start video
recording automatically.
3.2.2. Press the Power Button twice to stop video recording. The blue indicator light will come
on and stay illuminated, indicating the camera is back to standby mode.
3.2.3. Press the Power Button once again to resume video recording. The blue indicator light
will turn off.
[Note]:
1). A video clip will be generated and saved every 10 minutes automatically.
2). The camera can record video for 60 minutes continuously on a full charge.
3). Each video clip will take up about 780MB storage space of the internal memory.
4). Video Resolution: 1920x1080P Video Format: AVI
3.3. NIGHT VISION VIDEO RECORDING
3.3.1. Power on the camera by pressing the Power Button for 3 seconds. Both blue and red
indicator lights will be illuminated for 3 seconds and then turn off. The camera will start video
recording automatically.
3.3.2. Press the Mode Button for 3 seconds to turn on the IR LEDs. The red indicator light will
come on and flash 3 times then turn off while the IR LEDs will stay illuminated.
3.3.3. Press the Mode Button once again to turn off the IR LEDs. The blue indicator light will
come on and flash 3 times then turn off. The IR LEDs will turn off.